CoroDrill® 880-C - Insert For Drilling Insert Grade 1144

CoroDrill® 880 insert for drilling

Insert Usage Code - C
Insert Grade 1144
(M35)(S35) PVD (Ti,Al)N+(Al,Cr)2O3 coated insert for use on Stainless Steel and Heat Resistant Alloys.

Guide to Geometry/Feed:
-GM geometry is the basic choice for most materials. Medium feed.
-LM geometry is the best choice for long chipping materials, e.g. low carbon steel and stainless steels. Medium feed, insert with sharp positive edge.
-GR geometry is the high feed choice for steel and cast iron. Insert with strong reinforced edge, suitable for roughing.
-GT geometry is a problem solver for unstable conditions and interrupted cuts. Low to high feed. Good chip control in most materials.